Related Topics:
Hardening Information Implementing Zero-
Implementing VLANs on Aggregation Layer Switches
To configure the L2 aggregate switches, complete the tasks described in the following sections on all aggregate switches: Create and configure the EAPS domains. Enable the EAPS protocol. Configure VLAN aggregation on Switch B to add VLANs of different departments to a super-VLAN so that PCs in different departments can access the Internet using the super-VLAN. The configuration roadmap is as. This chapter covers the design recommendations for a data center design deployment consisting of a Cisco Nexus® 7000 Series Switch at the aggregation layer and a Cisco Nexus 5000 Series Switch at the access layer. The sub-VLANs are addressed from the same IP subnet and share a default gateway address, thereby reducing the. Each aggregation switch is physically connected to all edge switches and participates in multiple EAPS domains. · VLAN 20 on Device A can communicate with VLAN 20 on Device B. This information expands on standard LAGs. For the actual step-by-step process of setting up an MLAG, see the MLAG: Create an MLAG section on page 73 of the software manual from the download center.
[PDF Version]
-
How to check optical module information
Execute the following command to view detailed interface and optical module status: ethtool <devname> The output includes interface rate, module rate, link status (Link detected: yes is required for normal module operation), and interface configuration details. When the optical module on an interface is faulty, you can run the display commands to view information about the optical module. This example uses the Moduletek SFP-10G-LR module connected to an Intel X520. Next, let us use Moduletek SFP-10G-LR module to access the Intel X520 network card, to show you the operation of the Linux system to read the information on the network card access to the optical module. This guide provides complete, step-by-step CLI commands to view module type, DOM/DDM diagnostic data, vendor details, and compatibility information, fully. This article provides instructions on how to view the Optical Module Status on your switch through the Command Line Interface (CLI). The Cisco Small Business Series Switches allow you to plug in a Small Form-factor Pluggable (SFP) transceiver in their optical modules to connect fiber optic cables.
[PDF Version]