Related Topics:
Implementing Portsecurity Switchports Avoid-
Implementing VLANs on Aggregation Layer Switches
To configure the L2 aggregate switches, complete the tasks described in the following sections on all aggregate switches: Create and configure the EAPS domains. Enable the EAPS protocol. Configure VLAN aggregation on Switch B to add VLANs of different departments to a super-VLAN so that PCs in different departments can access the Internet using the super-VLAN. The configuration roadmap is as. This chapter covers the design recommendations for a data center design deployment consisting of a Cisco Nexus® 7000 Series Switch at the aggregation layer and a Cisco Nexus 5000 Series Switch at the access layer. The sub-VLANs are addressed from the same IP subnet and share a default gateway address, thereby reducing the. Each aggregation switch is physically connected to all edge switches and participates in multiple EAPS domains. · VLAN 20 on Device A can communicate with VLAN 20 on Device B. This information expands on standard LAGs. For the actual step-by-step process of setting up an MLAG, see the MLAG: Create an MLAG section on page 73 of the software manual from the download center.
[PDF Version]
-
Implementing relay protection in the State Grid
Recognizing the dire need for advanced relay protection, this report presents a comprehensive analysis of the evolving landscape. It outlines technical challenges, potential innovative solutions, equipment development trends, emerging market opportunities and new business models. revenue streams are being unlocked. Technologies such as. Synchrophasor technologies are being rapidly deployed to provide high-speed, high-resolution measurements from phasor measurement units (PMUs) across the transmission systems as a tool for monitoring and post fault analysis which may lead to real-time control using PMU data in near future.
[PDF Version]